Filter
Top Products
Boundary Microphone (Optional Accessory)
Boundary Microphone
(Proprietary cable included.
Cable length: approx. 8.5
m
[approx. 28 ft])
A
B
Part No.: KX-VCA001
MIC Mute button
Press to mute your own voice so that other video conference call participants cannot hear you.
(Page 46)
LED
Indicate the operational status of the Boundary Microphone.
Red (on): Microphone is muted.
Green (on): Transmitting
Orange (blinking in 1 second intervals): Starting up
Off: No transmission in progress
Note
• Up to 4 Boundary Microphones can be connected in cascade.
• Contact your dealer for purchase information.
Federal Communications Commission Requirements
Federal Communications Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions
manual,
may
cause harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
FCC Caution
To assure continued compliance, (example - use only shielded interface cables when connecting
to other devices). Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
For Canada Users
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Document Version 2010-10 Operating Manual 17
Preparation