Filter
Top Products
LED Patterns
LEDs indicate the operational status of the KX-VC500, as follows:
LED pattern Status
Slow blue flashing
• Starting up
• Idle state
Blue on
• In a video conference call (including when dialing,
receiving a
video conference call, and being disconnected)
Orange on
• Self diagnosis is being performed.
Orange flashing
• Mismatch of field frequency
*1
between the KX-VC500 and
display. (After 30 seconds the flashing will stop and the
KX-VC500 will restart in safe mode.)
Red on
• An error has occurred.
• Maintenance is being performed.
Red flashing
• A serious error has occurred.
Off
• Power is off.
• In screen standby mode
*1
Devices such as the display or video camera operate with a particular field frequency, depending on their video format. For details
on the field frequency, contact your dealer.
Screen Standby
When
there
is no video conference call transmission, and the KX-VC500 or remote control is not operated for
more than 10 minutes (default), or when the remote control’s [Video Out On/Off] button is pressed, the
KX-VC500 enters screen standby mode. Video out to the display is suspended and the status LED turns off.
Screen standby mode ends when the KX-VC500 or remote control is operated, or when a video conference
call is received.
Notice
• If screen standby mode ends and no image is visible, check to see if the display or video camera’s
power
saving settings are enabled. Check each device’s manual for more information about its power
saving settings.
Note
• You can change the length of time until the KX-VC500 enters screen standby mode. (
Page 74)
• The KX-VC500 will not enter screen standby mode while displaying a computer’s screen or a sub video
camera’s image, even if the KX-VC500 or remote control is not operated for a period of time.
• When the KX-VC500 or remote control is operated and screen standby mode ends, the Home screen
will be displayed.
• If a button is pressed on the KX-VC500 or remote control to end screen standby mode, that button’s
operation is not performed in that case.
• If screen standby mode begins while editing information in the contact list or other screen, any unsaved
changes will be lost.
18 Operating Manual Document Version 2010-10
Preparation