Filter
Top Products
60
■ VMD (Area Setup)
Set the VMD area.
The following window will be displayed when the [SET] but-
ton is pressed after moving the cursor onto "Set".
Green area: Set as the VMD area.
Clear area: Not set as the VMD area.
Red area: Cursor
Light blue area: Set as the VMD area, and currently motion
is being detected.
The VMD area can be set using the following buttons.
Arrows button: Select an area.
[SKIP d]/[SKIP s] buttons: Determine whether or not to
set the selected area as the VMD area (green: set as the
VMD area, clear: not set as the VMD area).
When completing the VMD area setting, press the [ESC]
button.
The "Alarm Rec. Setup" window will be displayed.
Move the cursor onto "OK" and press the [SET] button to
apply the settings.
Default: All areas are set as the VMD area.
Notes:
• The colors of the VMD areas may look not exactly as
described depending on the brightness or contrast of
the images displayed in the areas.
• The VMD area cannot be set for "Alarm No." to which no
video signal is supplied.
■ Advanced Setup
The following window will be displayed when the [SET] but-
ton is pressed after moving the cursor onto "Set→".
Configure the following settings on the setup window of
each "Alarm No." (☞ page 59).
Rec. Duration
Set the alarm recording duration.
000, 030 - 999 (sec)
When "000" is selected, recording will not stop until the
alarm is reset.
Default: 030 (sec)
Alarm Duration
Set the active duration of the alarm action (LED blinking,
buzzer sounding, alarm output from the terminal on the rear
of the recorder).
001 - 999 (Sec)
Default: 030 (Sec)
Alarm Output Port
Select a port from which an alarm signal is output.
0 - 4
When "0" is selected, no alarm signal will be output.
Default: 0
Alarm Spot Camera No.
Select a camera channel from which images are to be dis-
played on a single screen at an event occurrence.
1 - 16
Default: (Same value set for "Alarm No.")
Preset Camera No.
Select a camera channel that the connected camera is to
be moved to the preset position at an alarm occurrence.
1 - 16
Default: (Same value set for "Alarm No.")
Preset Position
Set the preset position to which the camera moves at an
event occurrence.
000 - 256
When "000" is selected, the camera will not move at an
event occurrence.
Default: 000
[All] button
When the [SET] button is pressed after moving the cursor
onto "All", the same settings will be applied to the following
for all of the "Alarm No.".
• Rec. Quality
• Rec. Frame Rate
• Time range of each schedule
• Sensitivity
• Rec. Duration (Advanced Setup)
• Alarm Duration (Advanced Setup)
• Alarm Output Port (Advanced Setup)
Cursor (red)
Green areas
(set as the
VMD areas)
Clear (colorless)
areas (not set as
the VMD areas)
No.01 Alarm Rec. Setup(Advanced)
Rec. Duration
060 Sec
030 Sec
Alarm Duration
Alarm Output Port
0
Alarm Spot Camera No.
01
Preset Camera No.
01
Preset Position
000
OK
Cancel