Filter
Top Products
64
■ Baud Rate
Select a line speed for data communication with the con-
nected device from the following.
2 400/4 800/9 600/19 200/38 400 (bps)
Default: 19 200 (bps)
■ Data Bit
The data bit will be displayed. It is impossible to change
the value.
■ Parity
A method of checking for errors in communication function-
ing will be displayed. It is impossible to change the value.
■ Stop Bit
The stop bit type will be displayed. It is impossible to
change the value.
■ Unit Address (System)
A unit address (Sys) is a unique number assigning to
PS·Data devices. The addresses must be unique to
identify system devices when connecting multiple
devices compatible with PS·Data.
Numbers, "001"-"099", are to be assigned as the unit
addresses to the system devices.
Default: 001
■ Unit Address (Controller)
A unit address (Ctrl) is a unit address assigning to con-
trol PS·Data devices. Numbers, "002"-"099", are to be
assigned as the unit addresses to the system controller.
Default: 002
■ Advanced Setup
The following window will be displayed when the [SET] but-
ton is pressed after moving the cursor onto "Set→".
■ DNS
Select "Manual" or "Auto" to enable IP address searching by
the host name using the DNS.
Select "Off" when not using the DNS.
Selecting "Auto" is available only when "On" is selected for
"DHCP" (using the DHCP server).
When "Manual" is selected for the DNS, enter the DNS serv-
er addresses in "IP Address (Primary)" and "IP Address
(Secondary)".
Enter 4 units from the decimal numbers (0-255) according
to the network configuration.
Default: Off
Server Port
Set the server port number of the recorder (required to use
the monitoring software).
1 - 65535
Default: 2000
w Configure the RS485 settings [RS485 Setup]
Configure the RS485 settings.
e Configure the PS·Data settings [PS.Data
Setup]
Configure the PS·Data settings.
OK
Network Setup (Advanced)
Cancel
OffDNS
---.---.---.---
IP Address (Primary)
---.---.---.---
IP Address (Secondary)
02000
Server Port
RS485 Setup
OK
19200Baud Rate
Cancel
8Data Bit
NoneParity
1Stop Bit
001Unit Address(System)
002
Unit Address(Controller)
9600Baud Rate
NoneParity
1Stop Bit
OffRetry Timing
1sAlarm Data
SetCamera Number Setup
8Data Bit
PS.Data Setup
OK Cancel