Filter
Top Products
ACCULINK 316x DSU/CSU
C-22 January 1997 3160-A2-GB21-50
Table C-7
(6 of 8)
User Interface Configuration Options
CmDiscTm: 5
Next Up Down Save Prev
Communication Port Disconnect Time. Specifies the period of time (1 to 60 minutes) before the communication port
disconnects due to inactivity. (The CmInActTm configuration option must be set to Enab.) Use the left or right arrow key to
position the cursor on the digit you want to change. Use the Function keys (Up or Down) to increment or decrement the
digit.
Up – Increments the time delay.
Down – Decrements the time delay.
Save – Stores the time delay for use with inactivity disconnects.
Modem Use: ASCII
Next Mgmt ASCII Term Prev
Modem Port Use. Specifies how the modem port is used.
Mgmt – Configures the modem port as the link to an SNMP or Telnet system.
ASCII – Configures the modem port as a proprietary ASCII port. This selection supports dial-out ASCII alarm messages
and dial-in/dial-out front panel access.
Term – Configures the modem port as the interface to an async terminal.
NOTE: This configuration option is available on standalone DSU/CSUs only.
F
Modem Type: Async
Next Async Sync Prev
Modem Type. Specifies whether the port uses synchronous or asynchronous communication if the modem port is
configured as the SNMP management link.
NOTE: This configuration option is available on standalone DSU/CSUs only.
F
NOTE: This configuration option is not available if the Modem Use configuration option is set to ASCII. In this case, the
modem port is always asynchronous.
Modem Rate: 2.4
Next 1.2 2.4 Prev
Modem Port Rate. Configures the bit rate for the modem port.
1.2 – Sets the bit rate at 1200 bps.
2.4 – Sets the bit rate at 2400 bps.
NOTE: This configuration option is available on standalone DSU/CSUs only.
F
MChar Len: 8
Next 7 8 Prev
Modem Character Length. Configures the character length (number of data bits) for the modem port. This does not
include the start bit (always 1) or the stop bits; 8 is the factory default.
NOTE: This configuration option is available on standalone DSU/CSUs only.
F
NOTE: This option must be set to 8 to perform PC emulation or pass-through operations, or SNMP management.
MParity: None
Next None Even Odd Prev
Modem Parity. Configures the parity for the modem port. None is the factory default.
NOTE: This configuration option is available on standalone DSU/CSUs only.
F