Filter
Top Products
ACCULINK 316x DSU/CSU
C-24 January 1997 3160-A2-GB21-50
Table C-7
(8 of 8)
User Interface Configuration Options
Aux Rate: 19.2
Next 9.6 14.4 19.2 38.4 Prev
Auxiliary Port Rate. Configures the bit rate for the auxiliary port.
9.6 – Configures the auxiliary port rate as 9600 bps.
14.4 – Configures the auxiliary port rate as 14,400 bps.
19.2 – Configures the auxiliary port rate as 19,200 bps.
38.4 – Configures the auxiliary port rate as 38,400 bps.
NOTE: This configuration option is available on standalone DSU/CSUs only. F
TnSession: Disab
Next Enab Disab Prev
Telnet Session Enable. Specifies whether the DSU/CSU responds to Telnet session requests.
Enab – The DSU/CSU responds to Telnet session requests.
Disab – The DSU/CSU does not respond to Telnet session requests.
TnPaswd: Disab
Next Enab Disab Prev
Telnet Password Mode. Specifies whether a password is required for Telnet access.
Enab – A password is required for Telnet access.
Disab – A password is not required for Telnet access.
TnInActTm: Disab
Next Enab Disab Prev
Telnet Inactivity Timeout. Specifies whether the Telnet session disconnects after a period of inactivity specified by the
TnDiscTm configuration option.
Enab – The Telnet session disconnects after the period of inactivity specified by the TnDiscTm configuration option.
Disab – The Telnet session does not disconnect due to inactivity.
TnDiscTm: 5
Next Up Down Save Prev
Telnet Disconnect Time. Specifies the period of time (1 to 60 minutes) before the Telnet session disconnects due to
inactivity. (The TnInActTm configuration option must be set to Enab.) Use the left or right arrow key to position the cursor
on the digit you want to change. Use the Function keys (Up or Down) to increment or decrement the digit.
Up – Increments the time delay.
Down – Decrements the time delay.
Save – Stores the time delay for use with inactivity disconnects.