Filter
Top Products
ACCULINK 316x DSU/CSU
H-2 January 1997 3160-A2-GB21-50
Initiating an Async Terminal
Session
Once the appropriate configuration option changes
have been made and access is established, the Main Menu
screen appears (unless a password is required).
Figure H-1 shows the Main Menu screen for a
standalone DSU/CSU.
The carrier-mounted DSU/CSU shows the 3000 Series
carrier slot number under the Customer ID. The slot
number field (e.g., Slot: 1
) is changed to access specific
DSU/CSUs in the carrier. For Telnet or SNMP access to
the carrier, specify the IP address of the applicable
communication port (see Appendix F, IP Network
Addressing Scenarios).
NOTE
By convention throughout this
appendix, examples of screens
are shown as they appear with
the standalone DSU/CSU.
If a password is required, the Login screen displays the
prompt for password input. (Refer to the Entering a
Password to Gain Access section on page H-12.)
To move between the Screen area and the Screen
Function Keys area (Figure H-1), press Ctrl-a (control key
and a).
From the Screen area, you may select the Status, Test,
Configuration, or Control branches.
Ending an Async Terminal
Session
To end the async terminal session from any screen,
press Ctrl-a to move from the Screen area to the Screen
Function Keys area (Figure H-1), and then select E
xit.
main
Customer ID: Node A Model: 31xx
Slot: xx
MAIN MENU
Status
Test
Configuration
Control
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions E
xit
Screen
Area
Screen
Function
Keys
Area
Figure H-1. Main Menu Screen