Pelco C2908M-B Universal Remote User Manual


 
C2908M-B (4/05) 11
FRONT PANEL COMPONENTS
The PelcoNet NET300 transmission system uses a compact design. For that reason connectors are placed on both the front and rear panels.
Key:
1 = Terminals for alarm input and relay output
Two alarm input terminals (
LN1/LN2)
Two
relay terminals (
R
) (for one relay)
Two ground
terminals
(
GND
)
(The two unmarked terminals are not supported.)
2=
Power
terminals for powering the NET300 unit
3 = RJ-45
Ethernet
connector for connecting to the network (10/100)
4 = Power
LED
lights when power is applied to the unit and flashes when transmitting/receiving video
5 = Network
LED
lights green when the unit is connected to the network
6 = Data
LED
flashes yellow when data is transmitted.
Figure 1.
Front Panel Connections
REAR PANEL COMPONENTS
Key:
1=
Video In
BNC socket (transmitter) or
Video Out
BNC socket (receiver) for video source or for an analog video monitor
2=
RS232/422/485
serial interface port; 9-pin male sub-D socket for controlling data transmissions (RS-232, RS-422, and RS-485
interfaces) and for configuration using terminal software
Figure 2.
Rear Panel Components
Refer to the Hardware Installation section for information on interfacing peripherals to the unit.
Ethernet
IN2
IN1
R
R
+
GND
RS232/422/485
Video In