Pelco C2908M-B Universal Remote User Manual


 
62 C2908M-B (4/05)
The following are arrayed down the right side of the page:
Radio buttons for 16 cameras
Iris open and close buttons
Focus far and near buttons
Zoom out and in buttons
Eight direction arrow buttons with a home button in the center to return the camera to its home position (preset 1)
Ten numbered buttons to use with the Pres and Pattern buttons to activate a preset and run patterns
A SET check box to use in programming presets and patterns
A Pattern button to run a pattern for each camera
“In Control” or “No Control” below the buttons indicates whether you have control of the camera. Recording control buttons are beneath the pic-
ture (live video page only).
On the Genex live control page, you can control the following:
Monitor—To select a monitor: click either the Main or Spot radio button.
Camera—To select a camera: click one of the 16 camera radio buttons.
Presets—To program a preset: set the image using the arrow keys, click SET, enter a preset number, and then click Pres. To activate a
preset, enter the preset number and click Pres. (You must click the Clear button before activating another preset.) Performing any PTZ
stops a scan preset.
Patterns—To program a pattern: click SET, click Pattern, run your pattern using the arrow keys, and then click Pattern again when you
are finished. To run a pattern, click Pattern. (You can run only the first programmed pattern.) To stop a pattern: click 96 and then click Pres.
Sequence—To activate a group camera sequence: click Sequence.