Filter
Top Products
8 C2908M-B (4/05)
Instructions for the Network Administrator
The PelcoNet NET300 transmission system allows live video transmission to be viewed over TCP/IP-based networks. This section is intended to
help the network administrator know what is involved with installing this product and how it will affect the network. The person installing the
product will need the following information about the network to make the network function properly.
THE TRANSMITTER AND RECEIVER
• A valid static IP address* for each PelcoNet NET300 transmission system unit
• Subnet mask*
• Default gateway (if applicable)
• E-mail server’s IP address (if applicable)
• Dedicated maximum allowable amount of bandwidth for live video**
* = Required for the PelcoNet NET300 transmission system to function properly
** = The PelcoNet NET300 transmission system requires a continuous amount of bandwidth to display true live video. Pelco recommends
using switching hubs with the product so the amount of bandwidth available to each unit is constant and reliable.
THE BROWSER
If you plan to use a browser to view live video across the network, there are procedures to complete before you can use the browser, such as
installing the ActiveX
®
platform. If you installed Microsoft
®
Internet Explorer 6.0 from the CD that came with the PelcoNet NET300 transmission
system, you can skip step 1 below. Otherwise, perform the following before trying to use the browser.
1. Internet Explorer 6.0 or higher must be installed before continuing.
2. Set the computer’s display settings to use 16- or 32-bit color.
3. Insert the supplied CD. It will open automatically.
If it fails to open automatically
, perform steps a through d below.
a. Click the
Start
menu in the Windows
®
operating system.
b. Click
Run
.
c. In the Open box, type
D:\START.EXE
(where D:\ = your CD ROM drive letter).
d. Click
OK
.
4. Click
Software
and then click
Install PelcoNet ActiveX
.
5. Follow the on-screen setup instructions to finish installing the plug-in.