Filter
Top Products
C2908M-B (4/05) 53
r – RCP+ Menu
‘e’ Local video coder number 1
‘D’ Remote video decoder number 1
‘c’ Display connection list
‘1’ Connect to Alarm IP 0.0.0.0
‘2’ Disconnect this Connection
‘3’ Disconnect all Connections
‘5’ Join Stream 0.0.0.0
‘x’ Leave this Menu
‘?’ This Menu
m – Misc Menu
‘v’ Get Version Info
‘x’ Leave this Menu
‘?’ This Menu
TERMINAL PROGRAM RECEIVER MENU STRUCTURE
The following describes the terminal program receiver menu structure. The menu items and commands are enclosed in single quotation marks.
Do not enter the quotation marks. Information and current settings are displayed to the right of the commands. Refer to the Command Reference
section for descriptions of the commands.
Main Menu
‘i’ IP
‘r’ RCP+
‘m’ misc
‘?’ This Menu
‘q’ exit/logout
i – IP Menu
An asterisk (*) means a reset of the NET300 is necessary after a change. Reset by cycling the power.
‘i’ (*) local IP 10.0.0.2
‘s’ (*) local subnet mask 255.255.255.0
‘g’ (*) local gateway 0.0.0.0
‘r’ remote IP 0.0.0.0
Mac Address 00-07-5f-50-00-06
‘a’ Auto Connect Off
‘m’ Set HD/FD 10/100 auto mode
‘p’ Ping remote IP 0.0.0.0
‘l’ RTP Packet Loss Stats
‘x’ Leave this Menu
‘?’ This Menu
r – RCP+ Menu
‘E’ Local video coder number 1
‘d’ Remote video decoder number 1
‘c’ Display connection list
‘1’ Connect to Alarm IP 0.0.0.0
‘2’ Disconnect this Connection
‘3’ Disconnect all Connections
‘5’ Join Stream 0.0.0.0
‘x’ Leave this Menu
‘?’ This Menu
m – Misc Menu
‘v’ Get Version Info
‘x’ Leave this Menu
‘?’ This Menu