Filter
Top Products
Pelco Manual C1995M-A (10/01) 39
MX4000SVR (SINGLE MODE) START-UP TEST
1. Press 1 on the keyboard, and then UNIT.
2. Press MAIN.
3. Press the 4-screen button. The picture should change.
4. Press SPOT.
5. Press button 1 on the multiplexer.
6. Press 1, Cam, 2, Cam. The monitor should display a full-screen image of camera 1,
and then camera 2.
ALARM, RELAY, AND VCR
1. Select the four-screen display on the multiplexer. Four cameras should be displayed.
2. Short the alarm 1 contact (refer to Figure 11). The monitor that is set to respond to
alarms should switch to camera 1 and the VCR should start recording.
NOTE:
You must initialize
the keyboard after a power
failure or after unplugging
and reconnecting the key-
board.