Filter
Top Products
14
Polaview 215E LCD Projector User’s Guide
Introduction
Before using the remote control
Load the 2 “AA” batteries into the remote control
unit.
1.
Slide the lid in the direction of the arrow.
2.
Install 2 “AA” batteries as indicated inside the
battery compartment.
3.
Replace the lid and snap it into place.
Battery replacement caution
Do not mix old and new batteries. (Also never mix
alkaline with manganese batteries)
Note:
Do not place the remote control
unit upside down, otherwise the mouse
button may be pressed down, which
will cause the battery power to be
consumed.
Remote control unit operating range
When using the remote control unit, point it at the front or rear of the LCD
projector or at the projection screen. The range for optimum operation is within 30
degrees of the receiver at a maximum distance of about 23 feet (7m).
Remote control unit light up
Press the LIGHT button to illuminate the function buttons on the remote control
unit for 10 seconds. The light goes out while any button is pressed, and then turns
back on for an additional 10 seconds when the button is released.
!