Filter
Top Products
62 Polaview 215E LCD Projector User’s Guide
Appendix
Appendix
Maintenance
Warning Indications
Status Code Display Indications
This LCD projector has a STATUS CODE display that calls your attention to
problem conditions existing inside the LCD projector. The LCD projector displays
a status code indication each time an internal problem is detected. If any of the
following indications appear in the STATUS CODE display, immediately turn off
the MAIN power. Then, see the chart below.
S
T
A
N
D
A
R
D
VOLUME
MODE
MENU
INPUT
STATUS
CODE
S-VIDEO
VIDEO IN
L-AUDIO-R
RS232C
RGB IN
AUDIO IN
RGB OUT
AUDIO OUT
MAIN
MAIN
OFF
ON
STATUS CODE display
Status Code Symptom Problem Possible Solution
F-L Lamp unit automatically
turns off due to abnormally
high internal temperature.
(Standby-by condition)
Cooling fan malfunction Take the LCD projector
to your nearest Service
Center.
F-O Misinstalled air filter unit. Properly install the air filter
unit.
A-n Temperature sensor
malfunction.
Take the LCD projector
to your nearest Service
Center.
A-0
A-1
Clogged air filter.
Blocked air intake.
The surrounding tempera-
ture of the place of use may
be too high.
Clean the filter
(See page 63).
Relocate the projector to a
proper location.
Place the projector so that
the surrounding tempera-
ture is between 5˚C(41˚C
(104˚F) and the humidity is
between 10% and 80%
(with no condensation).
L-n
P-2
Lamp does not light up. Lamp is burned out.
Lamp voltage is not correct.
Take the LCD projector
to your nearest Service
Center.
P-3
P-4
Abnormally high internal
temperature.
Abnormal temperature rise.
Other cause.