Filter
Top Products
English 33
Getting started
Basic LCD projector operation
Before you begin, make sure…
• You have read Important safeguards. (See page 7)
• All connections are made. (See page 20)
• The LCD projector is positioned properly. (See page 31)
• The LCD projector is plugged in.
• The lens cap is removed.
1. Turn on the power.
(See “Turning the power on and off” on page 30)
2. Press INPUT on the LCD projector or remote control unit to select the
desired input signal.
Continue to press INPUT to set the desired input signal. Each press will
change the display as shown above.
You can turn the input signal display off. (See “Turning off the input signal
display” on page 36.)
3. Turn on your computer (RGB) or start video playback (S-VIDEO or
VIDEO).
Adjust FOCUS and ZOOM rings if necessary. (See “Adjusting the lens” on
page 19)
POWER
MODE
FREEZE SHUTTER
MENU INPUT
LIGHT POINTER
MUTE VOLUME
STANDARD
S
T
A
N
D
A
R
D
VOLUME MODE
MENU
INPUT
STATUS
CODE
a
g
f
e
b
c
d
a VOLUME +/- buttons
b INPUT button
c FREEZE button (remote control)
d MUTE button (remote control)
e INPUT button (remote control)
f VOLUME +/- button
(remote control)
g SHUTTER button
(remote control)
RGB PC-CARD S-VIDEO OR VIDEO