Filter
Top Products
English 67
Appendix
4. Remove the lamp unit screw.
Remove the lamp unit screws (2), then grasp the lamp unit handle and carefully
pull it from the LCD projector. Keep the lamp housing opening to your right.
Do not touch the lamp or point the lamp opening at anyone.
Warning: The lamp may be hot. Be careful when handling.
Caution: High-pressure lamps may explode if improperly handled.
Danger of injury due to lamp fragments.
5. Install the new lamp unit.
Remove the 630146 lamp from the LCD projector and install a new lamp unit.
(630146)
Do not drop. The impact of dropping may cause the lamp to explode.
6. Replace the lamp unit screws.
Replace the lamp unit screw and the lamp cover screws using a coin to tighten.
Properly dispose of the old lamp.
7. Plug the LCD projector back in by inserting the power cord into the
LCD projector AC socket, and set the MAIN power switch to ON.
8. Press POWER to turn the LCD projector ON.
9. Press MENU to display the menu.
lamp unit screws
coin
S-VIDEO
VIDEO IN L-AUDIO IN-R RS232C RGB IN AUDIO IN AUDI
O
RGB OIUT
lamp unit
RGB ADJUST
RGB SYNC MENU
>SET UP PROJECTOR
LANGUAGE
/SPRACHE /LANGUE
/IDIOMA /LINGUA
SELECT : PUSH ។or៓
SET : PUSH ្or៑
END : PUSH MENU
FRONT/REAR FRONT
INPUT DISP ON
REMOTE POWER ON
EXPANSION (VGA) ON
>LAMP TIME RESET NO
SELECT : PUSH ។or៓
SET : PUSH ្or៑
END : PUSH MENU
MENU
SET UP PROJECTOR