Filter
Top Products
66 Polaview 215E LCD Projector User’s Guide
Appendix
Lamp replacement procedure
Caution: Because of possibility of injury, strictly follow the lamp replacement
procedure outlined below.
Order Lamp: 630146 Tools required: A coin.
1. After the cooling fan has stopped and the STANDBY(R) ON(G) indicator
turns solid red, set the MAIN power switch to OFF and unplug the power
cord.
Note: Please wait more than one hour before replacing the lamp.
If you need to replace the lamp more urgently
1.
The LCD Projector has a forced cooling feature. After the POWER switch is
turned OFF, and sometime during the first minute of the cooling fan operation,
press ្ and ៑ at the same time. The cooling fan will change to high speed for
about 10 minutes. (The “C-d” STATUS CODE will be displayed.)
2. Grabbing the handle, place the LCD projector up on its side as
illustrated.
3. Remove the lamp cover screws.
First read the caution and warning labels on the lamp cover. Then, remove the
lamp cover screws (2) by using a coin, and take off the lamp cover.
S
T
A
N
D
A
R
D
VOLUME
MODE
MENU
INPUT
STATUS
CODE
S-VIDEO
VIDEO IN
L-AUDIO-R
RS232C
RGB IN
AUDIO IN
RGB OUT
AUDIO OUT
MAIN
MAIN
OFF
ON
MAIN power switch
coin
lamp cover
screws