Sony DVP-S9000ES DVD Player User Manual


 
2
Welcome!
Thank you for purchasing this Sony
SACD/DVD Player. Before operating this
unit, please read this manual thoroughly
and retain it for future reference.
WARNING
To prevent fire or shock
hazard, do not expose the
unit to rain or moisture.
To avoid electrical shock,
do not open the cabinet.
Refer servicing to qualified
personnel only.
Mains cord must only be
changed at a qualified
service shop.
This appliance is classified as a
CLASS 1 LASER product. The CLASS
1 LASER PRODUCT MARKING is
located on the rear exterior.
CAUTION
The use of optical instruments with this
product will increase eye hazard. As the
laser beam used in this SACD/DVD player
is harmful to eyes, do not attempt to
disassemble the cabinet.
Refer servicing to qualified personnel only.
This label is located on the Laser protective
housing inside the enclosure.
Notice for customers in the
United Kingdom and Republic of
Ireland
A moulded plug complying with BS1363 is
fitted to this equipment for your safety and
convenience.
Should the fuse in the plug supplied need
to be replaced, a 5 AMP fuse approved by
ASTA or BSI to BS1362, (i.e., marked with
or mark) must be used.
If the plug supplied with this equipment
has a detachable fuse cover, be sure to
attach the fuse cover after you change the
fuse. Never use the plug without the fuse
cover. If you should lose the fuse cover,
please contact your nearest Sony service
station.
Precautions
Safety
• This unit operates on 220 - 240 V AC,
50/60 Hz. Check that the unit's
operating voltage is identical with your
local power supply.
• If anything falls into the cabinet, unplug
the unit and have it checked by qualified
personnel before operating it any further.
• The unit is not disconnected from the
mains as long as it is connected to the
mains outlet, even if the unit itself has
been turned off.
• Unplug the unit from the wall outlet if
you do not intend to use it for an
extended period of time. To disconnect
the cord, pull it out by the plug, never by
the cord.
Installing
• Allow adequate air circulation to prevent
internal heat buildup.
• Do not place the unit on surfaces (rugs,
blankets, etc.) or near materials (curtains,
draperies, etc.) that may block the
ventilation slots.
• Do not install the unit near heat sources
such as radiators or air ducts, or in a
place subject to direct sunlight, excessive
dust, mechanical vibration or shock.
• Do not install the unit in an inclined
position. It is designed to be operated in
a horizontal position only.
• Keep the unit and discs away from
equipment with strong magnets, such as
microwave ovens or large loudspeakers.
• Do not place heavy objects on the unit.
• If the unit is brought directly from a cold
to a warm location, moisture may
condense inside the SACD/DVD player
and cause damage to the lenses. When
you first install the unit, or when you
move it from a cold to a warm location,
wait for about 30 minutes before
operating the unit.