Filter
Top Products
Page 23
Installing the Receiver
When the software upgrade is complete, you will see a second message that
the receiver's memory is now being programmed. This message may
disappear and your screen may go blank for a few minutes. This is normal
and does not indicate a problem with the receiver.
8. When the software upgrade is complete and the receiver resets itself, you
should now be able to order your programming by calling 1-800-333-DISH
(3474). See Chapter 1, Introduction.
Setting the HDTV Resolution
When the receiver has been activated with qualifying DISH Network
programming, use the following steps to select the desired HDTV format:
1. Consult your HDTV user’s guide for the HD format that the TV supports
(1080i, 720p or 480p). If required, set up the HDTV to display in the format
you desire. Some HDTV's will automatically adjust to the resolution setting
of the receiver.
2. Press MENU 6-1-9 on the receiver remote control to bring up the receiver
HD Setup screen.
3. Select the HD format under TV type that matches the format your TV is set
up to support. Press
Save to save these settings.
4. If you were using the standard definition A/V input, switch your HDTV to
display from its DVI or YP
BPR component inputs. Consult your HDTV
user guide for instructions.
5. Confirm you are watching picture from the receiver over the HDTV
connections.