Filter
Top Products
Page 34
Chapter 3
Using the System
dish home Button
Press the DISH button on your remote control to use dish home
Interactive TV
.
Format/Star Button
Press the FORMAT/STAR button to toggle through the available
display modes (Normal, Zoom) on widescreen displays.
Recover Button
Press the RECOVER button if you accidentally change the
channel or video input on your TV and cannot get the picture
back from your satellite receiver. When you press the
RECOVER button as described below, the remote control sends commands
to your TV to change channels or video inputs to try to get you back to
watching satellite programming. This procedure works only if you have
accidentally changed the TV channel or video input. It does not recover lost
satellite signal (See Chapter 4 - Reference for troubleshooting information).
RECOVER only works if the remote control has been set up to control the
TV and/or VCR, if connected.
Note: You may need to press the RECOVER button up to 30 times to
recover your satellite TV video.
1. Press and hold the RECOVER button until all four mode buttons light,
and then let go of the button. The SAT mode button flashes twice and
then all four mode buttons flash three times.
2. Press the RECOVER button. Wait for the TV mode button to flash
once and then all four mode buttons to flash once.
3. If you see the
System Info screen, press the SELECT/OK button to
close the screen. You have recovered your satellite video.
4. If you do not see the
System Info screen, repeat steps 2 and 3 until you
have recovered your satellite video.
Note: If you have a DISH Network HD monitor, you may be able to use the
SAT button instead of the RECOVER button to restore your TV back to
watching satellite programming. See your DISH Network HD Monitor
User’s Guide for details. Other buttons on your remote control that do not
operate your satellite receiver are reserved for future use.