Filter
Top Products
Before You Begin
1 Load the configuration file for chapter 3, CH03_60._A.
If you need instructions to load the configuration files, refer to chapter
11, "To Load a Configuration File."
2
Connect Pod 1.
Connect Pod 1 of the analyzer to J1 on the Training Board. For the
HP 1660s, Pod 1 is the top cable in the left-most position when you are facing
the rear of the logic analyzer.
3
Set the jumpers as shown below
The jumper setting of J5 on the training board for this chapter are the same
as the default settings. For more information about setting the jumpers, refer
to chapter 11, "To Set the Jumpers."
CLK2
GLITCH
P. G.
OSC
CLK2
OFF
ON
CLK1
P. G.
Using the Pattern Generator
Before You Begin
9-3