Filter
Top Products
Comparing State Traces
The State Compare feature allows you to compare two state listings.
You can check if your system is executing correct states by acquiring
a state listing from the system under test and comparing it to a listing
that is known to be good. If there are differences between the two
listings, you can use the Difference Listing feature to see where the
differences occur.
In these exercises, you will run a test and store the state listing as the
reference listing. Next, you will change the jumper settings and run a
different test using the same trigger specification. You will then use
the Difference Listing to see the differences between the two listings.
These exercises will step you through the process of using the
Compare mode of the state analyzer. They are designed to use many
of the same exercises as the State Analyzer Exercises in the previous
chapter; therefore, the beginning exercises do not include figures or
explanations. If you need this additional information on any of these
common exercises, refer back to the same exercise in chapter 3,
"Introduction to State Analysis."
In this chapter, you will:
• Put the analyzer into state mode
• Set up the state clock
• Change a label name and modify channel assignments
• Define a term for the state trigger
• Set up the state trigger specification
• Run the analyzer and view the state listing
• Copy the state listing to the compare reference listing
• Change the jumper to acquire a different state listing
• Run the analyzer and find the errors
4-2