Filter
Top Products
Connect the Pattern Generator
• Connect the pattern generator output Pod 4 to the TTL Data Pod.
Then connect the TTL Data Pod to J4 (labeled PATTERN
GENERATOR) on the training board.
For more information about setting the jumpers, refer to chapter 11, "To Set
the Jumpers."
Note Pod 1 of State/Timing is not only used to acquire the pattern generator’s
output pattern, it also provides the needed + 5V for the training board.
Connecting the Pattern Generator
Pod 4 of the pattern
generator.
J4 - The TTL Data Pod,
with Pod 4 of the
pattern generator
attached, connects to
the training board here.
J1 - Pod 1 of the
analyzer connects
here.
Using the Pattern Generator
Connect the Pattern Generator
9-4