Filter
Top Products
Run the State Analyzer and View and Change the State
Listing
1 Press the Run key.
2 Observe the State Listing.
The trigger pattern 00 is centered around the zero line number, which
corresponds to the trigger point you specified in the Trigger menu. The
negative line numbers indicate the states stored prior to the trigger point.
State Listing Menu
3 Use the table below to view and change the state listing.
To Do This: Do This:
To change the state listing
display from hex to decimal
Highlight the
Hex field directly below the SCOUNT label,
and press the
Select key. Choose Decimal from the
pop-up menu.
To scroll through the state listing On the left-center side of the display, highlight the line
number field, then turn the knob.
To page through the state listing
one screen at a time
Press the
Page keys below the knob.
Trigger point 00
The line numbers
show the locations
of the data in the
logic analyzer’s
memory.
This is the state data
you acquired from the
ripple counter.
Introduction to State Analysis
Run the State Analyzer and View and Change the State Listing
3-11