Set the Jumpers
You will create the glitch on bit 7 of the counter on the training board by
setting the glitch jumper to ON.
• Set the jumpers as shown below.
For more information about setting the jumpers, refer to chapter 11, "To Set
the Jumpers."
Setting the Jumpers
Result The glitch on bit 7 is turned on.
CLK2
GLITCH
P. G.
OSC
CLK2
OFF
ON
CLK1
P. G.
J1
Triggering the Oscilloscope with the Timing Analyzer
Set the Jumpers
8-4