Filter
Top Products
Filter the Captured Data
Note This exercise can only be done with the HP 1660C, HP 1660CS,
HP 1661C, or the HP 1661CS analyzer.
If the program you are running is large or you are not interested in looking at
all of the code, you can suppress the types of instructions you are not
interested in. In this exercise you will look at the general flow of the code by
showing only the jumps and suppressing all other types of instructions.
1
Highlight the Invasm Options field and press the Select key.
2 Suppress all of the instruction types, except "Jumps:", by highlighting
each field and pressing the
Select key.
3 Press the Done key to close the Inverse Assembly Options pop-up.
4 Use the knob to scroll through the listing of jumps.
Filtering the Captured Data
Result The captured data can be filtered in various ways. In this exercise, the
inverse assembly code is filtered so that only the jump instructions are
displayed.
Introduction to Inverse Assembly
Filter the Captured Data
10-6