Filter
Top Products
259
Chapter
3
Error
Messages
Error Message (Alphabetically) Cause Action
AF error. Laser barrier may be
closed
The digitizer was not ready due to an
AF error.
Click the [OK] button to close the mes-
sage dialog box.
AF error.
The digitizer was not ready due to an
AF error.
Click the [OK] button to close the mes-
sage dialog box.
Calculation disable.
Failed to calculate using the specied
corresponding points.
Click the [OK] button to close the mes-
sage dialog box.
*When selecting correspondence points,
you must select points so that they are
sufciently spaced and so that are within
the range that can be specied within the
element’s colorimage window.
Cannot display wireframe.
The command was selected even though
the currently displayed color image was
the one added to the data taken by the
digitizer.
Click the [OK] button to close the mes-
sage dialog box.
Cannot show information of more
than 20000 points. (Number of
selected points – 20000) Points
will be omitted.
More than 20000 points were selected. Click the [OK] button to display the
[Info-Points] dialog box. Information for
the extra points (i.e. the points exceeding
– 20000) will not be included.
Choose more than 2 points.
An attempt was made to extract a line
without selecting two or more points.
Click the [OK] button to close the mes-
sage dialog box.
Choose more than 3 points.
An attempt was made to extract a face
or circle without selecting three or more
points.
Click the [OK] button to close the mes-
sage dialog box.
Choose more than 4 points.
An attempt was made to extract a sphere
without selecting four or more points.
Click the [OK] button to close the mes-
sage dialog box.
Create Meshes Fault!
Failed to ll holes.
(This message appears if creation of
meshes fails with “Fillholes by meshes”
or “Replace meshed” selected.)
Click the [OK] button to close the mes-
sage dialog box.
Design value is same as that of
others.
The design values of the extracted point
are the same as those of the extracted
line.
Click the [OK] button to close the mes-
sage dialog box.
Extracted line’s vector overlaps
The extracted line’s vector is the same
as the other line’s vector.
Click [OK] button to close message
dialog box.
Extracted point overlaps
The extracted coordinate (X, Y, Z) is the
same as the other’s coordinate.
Click [OK] button to close message
dialog box.
Extraction failure. Please select
again.
Fail extraction of Point, Line or Face. Click [OK] button to close message
dialog box.
File write error.
A write error occurred, for instance, due
to an excessively long le path name.
Click the [OK] button to close the mes-
sage dialog box.
File write error: user preferences.
A write error occurred. Click the [OK] button to close the mes-
sage dialog box.
No preference le will be created even if
the [OK] button is clicked.
(The settings will be lost if this software
is exited.)
Error Messages
The following error messages appear if incorrect operation is performed or an abnormality occurs. If an error
message appears, take the appropriate corrective actions as shown in the table below.