Konica Minolta VI-700 Universal Remote User Manual


 
50
Chapter
2
File
Menu
910
File – Import – Digitizer – One Scan (When VIVID 910 is Selected)
Performing One Scan with the VIVID 910
This command is used to cause the VIVID 910 (VI-910) to scan the object one scan at a time using the remote
control function of this software. Registration of multiple scan data can be performed by manually designating
their corresponding points.
Warning
Never stare into the laser emitting window.
Do not place a lens, mirror or optical element in the passage of the laser beam. Doing so may converge the
laser beam, resulting in damage to your eyes, burns or re. To prevent the above accidents, make sure that a
wall or similar which can block the laser beam is located behind the object.
M
emo
Before performing the procedure below, make sure that
the digitizer you are going to use is selected by the File
– Select Digitizer command.
Ref.
For details of the File–SelectDigitizercommand,
refer to page 144.
Operating Procedure
1
From the [File] menu, select [Import],
[Digitizer] and then [One Scan].
The [File-Import-Digitizer-One Scan] dialog
box will appear.
The monochrome monitor image captured by the
VIVID 910 will appear in the Work window area
of the dialog box.
3
To display the object in the middle of the
Work window area , change the posi-
tion of the object or move the instrument
back and forth to change the view angle.
2
Set an object in place.
If you are going to use the rotating stage,
place the object on it.
M
emo
If necessary, replace the lens attached to the VIVID.