Filter
Top Products
197
Chapter
2
Build
Menu
9i
910
900
700
300
n Extracting a Line
Extract a line from the selected points as explained below.
Operating Procedure
The following steps must be carried out in Build – Move – To X-Y-Z mode.
Parameters for [Select Line Attribute] Dialog Box
X-Axis
Generates the X-axis based on the selected points.
Y-Axis
Generates the Y-axis based on the selected points.
Z-Axis
Generates the Z-axis based on the selected points.
1
Select the desired points.
M
emo
• Select the points using the Select and View menu com-
mands.
• After operation, please cancel the Select or View menu
command.
4
Click the [OK] button.
The line direction will be displayed, and the
[Question] dialog box will appear.
5
If you want to change the direction,
click the [No] button.
The line direction will be changed, and the
[Question] dialog box will reappear.
6
Click the [Yes] button.
The generated line will be displayed, and the
[Conrmation] dialog box will appear.
7
Click the [OK] button.
Proceed to the extraction procedure for the
next element (point or line).
• When you have completed extraction of all ele-
ments: Right-click the mouse to open the Ques-
tion dialog, and proceed to convert to the new
coordinate system.
2
Click the right mouse button.
The [Select Line Attribute] dialog box will ap-
pear.
3
Select the desired line attribute from
the pull-down menu.
Build – Move – To X-Y-Z