Filter
Top Products
19
5. Remove the HDD from the hard disk mounting
bracket.
6. Install the new HDD in the reverse order to when
replacing the hard disk drive.
7. After replacing the hard disk drive, insert the
power plug into the outlet and turn the power of
the unit on.
Notes:
• When you install or replace the HDDs to the
hard disk mounting bracket, you must set the
HDD jumper to slave or master.
You must install the HDD as shown below.
- Upper sides: Set the master HDD.
- Lower sides: Set the slave HDD.
• How and where to set the HDD jumper depends on
the manufacturer or model specification. Therefore,
carefully read the instructions printed on top of the
product or in the manual enclosed with the product
before installing the jumper.
- If the jumper pin settings are identical with each
other in terms of priority, either HDD may not be
detected in the DVR or malfunction may occur.
• Make sure that each of the IDE cables is connect-
ed to the connector housing through its holes.
• Do not stack them nor keep them upright.
• Do not use an electric screwdriver to fix them.
Before Operating the System
Before Operating the System
You can select the main monitor type to display the
main screen.
1. Insert the power plug to an outlet.
(Make sure the power source is AC 100~240V,
50/60Hz)
2. Turn on the main power switch on the rear panel.
The power indicator LED on the front panel will
show a red light.
3. Select monitor type.
VGA Monitor:
When you connect the VGA jack on the rear of
the DVR, press and hold the MAIN button on
the front panel until the beep sounds to
display the main screen.
CCTV (Composite Video Type) Monitor:
When you connect the MAIN-OUT or
S-VIDEO jack on the rear of the DVR, press
and hold the SPOT button on the front panel
until the beep sounds to display the main
screen.
Note:
You can select the monitor type by using the
MAIN or SPOT button at anytime. If you change
the monitor type, the system will be rebooted
automatically.
4. Turn on the sub-power.
HOOKUP AND
SETTINGS
Recommended HDD
The following HDD has been
tested and compatibility is
ensured. When you attach multi-
ple HDDs use the recommended
HDDs.
Maker
Hitachi
Seagate
RPM Capacity
7,200 80 GB
7,200 160 GB
7,200 250 GB
7,200 320 GB
7,200 500 GB
7,200 200 GB
7,200 250 GB
7,200 300 GB
7,200 500 GB
Model No.
HDS728080PLAT20
HDT722516DLAT80
HDT722525DLAT80
HDT725032VLAT80
HDT725050VLAT80
ST3200827ACE
ST3250824ACE
ST3300822ACE
ST3500841ACE
Interface
Ultra
ATA133
Ultra
ATA100