Filter
Top Products
31
Event Settings
Event Settings
Sensor
z In: Displays the number of the SENSOR-IN terminal.
z Sensor Type: The alarm state can be set to either
N.O. (Normally Open) or N.C. (Normally Closed).
z Camera: Select the connected camera channel to
the SENSOR-IN terminal.
z Output: Select the alarm output number for the
ALARM-OUT terminal for the output alarm signal.
Motion
z Channel: Select the channel to set motion detec-
tion.
z Sensitivity: Set the level of sensitivity for the creat-
ed motion detection area. Sensitivity can be set
from level 0 to 10.
z Alarm Out: Select the number of the ALARM-OUT
terminal for the output alarm signal when motion is
detected.
z Area: Select the desired motion detection area on
the preview window screen.
- b / B / v / V: Moves the yellow cell box to
another cell zone.
- ENTER: Selects or cancels the motion
detection area at the current cell position.
- Press ESC to exit the settings.
Note:
You can select the motion detection area by using the
mouse.
- To select the area: Drag & drop a cell to the right
to select the motion detection area.
- To cancel area: Drag & drop a cell point of a
selected cell area to the left to cancel the motion
detection area.
Etc
z Alarm Off
- MANUAL: Use the ALM.OFF button to stop alarm.
- POST-ALARM TIME: The alarm is stopped after
post-alarm time.
HOOKUP AND
SETTINGS