Filter
Top Products
61
REFERENCE
REFERENCE
T
T
roubleshooting
roubleshooting
Check the following guide for the possible cause of a problem before contacting service.
Resolutions
• Check the power cable is connected correctly.
• Check the input voltage is correct.
• Make sure that the main power switch on the rear panel is set to ON.
• If the system power does not turn on even if the power cable is connected
correctly, please contact the service center.
• Check the monitor power cable is connected properly.
• Make sure the monitor is turned on.
• Check the video output cable of the LDV-S500 DVR is properly connected to
the monitor.
• Check the selected monitor type (see page 19).
• Unplug the power cable and plug in again.
• Check the camera video output is connected to the DVR system correctly.
• Check the power cable on the camera is connected correctly.
• Check there is no problem with the video cable connection from the camera to
the LDV-S500 DVR system.
• Turn off the DVR system and turn it on again.
• Check the recording mode in the record setting menu.
• Check the HDD detection status in the System Information window.
If the HDD detection status is abnormal, check the HDD formatting and the
connection of the HDD.
• Check the recordable disk space in the HDD.
• Check the overwrite option in the setup menu for overwrite recording.
• Check if there is recorded video data at the time that you are trying to search
on the table.
• If there is no recorded video data, check the recording mode in the record set-
ting menu.
• Check the HDD detection status in the system information window.
If the HDD detection status is abnormal, check the HDD formatting and the
connection of the HDD.
• Check the user type. The search function is not available for a normal user.
Symptoms
The system power
does not turn on.
The system power is
turned on but no video
data is displayed on
the monitor.
The camera numbers
are displayed on the
screen but the camera
images are not
displayed.
The camera video is
shown on the screen
but the system does
not record the video.
It is impossible to
search through the
recorded video.