Filter
Top Products
17
Reference frequencies
During tape playback, the video output reference frequencies are as shown in the table below.
<Notes>
z During SD tape playback, operation is not possible in the 60 Hz mode.
z When the HD SDI output signals are output at 60 Hz/24 Hz, the SD SDI signal is output in the NO SYNC status, and the
analog composite signals are output in black-and-white mode (burst OFF).
z All the HD SDI output, SD SDI output, analog composite output, analog component output, audio output and TC output
signals are output in phase with the REF input.
59.94 Hz/60 Hz operation specifications
Input signals Menu item No.031
REF_IN INPUT AUTO HD_REF SD_REF INPUT
HD_REF_IN
Input
Complies with
HD REF IN
frequency
Complies with
HD REF IN
frequency
59.94Hz
Complies with
INPUT
frequency
Not input
Complies with
HD REF IN
frequency
Complies with
HD REF IN
frequency
59.94Hz
Complies with
menu item No.030
frequency
SD_REF_IN
Input 59.94Hz
Complies with
menu item No.030
frequency
59.94Hz
Complies with
INPUT
frequency
Not input 59.94Hz
Complies with
menu item No.030
frequency
59.94Hz
Complies with
menu item No.030
frequency
None Not input
Complies with
menu item No.030
frequency
Complies with
menu item No.030
frequency
59.94Hz
Complies with
menu item No.030
frequency
When “90H” is selected as the menu item No.26 HD SYS H ADV, the HD output is output with a phase 90H ahead of the SD
output.
When the SD REF signal is input, the REF input and SD output signals are inphase, and when the HD REF signal is input,
the REF input and HD output signalsare in-phase.
z The audio output and TC output signals are output in-phase with the HD output signals.
z With the 720p format, there is a phase difference of 120H.