Filter
Top Products
24
Pause/Recording (Recording with pauses)
1 Press the PAUSE button during playback of the cassette
tape.
2 Press the REC button to move to the REC PAUSE mode.
When menu item No. 154 AUTO BACK is set to “REC-P”
or “ALL,” the tape is rewound for a few seconds from the
position where the PAUSE button is pressed.
3 Press the PAUSE button to start recording.
The tape runs to the position where the PAUSE button is
pressed as mentioned in 1 above, and recording starts.
4 Press the PAUSE button again to pause the recording.
When menu item No. 154 AUTO BACK is set to “REC-P”
or “ALL,” the tape is rewound for a few seconds from the
position where the PAUSE button is pressed, and then
paused.
5 By repeating the operation in 3 and 4 above, it is possible
to record with pauses.
Cue up
When recording with pauses, the time codes of the starting point and the stopping point of the recording are automatically
backed up. However, the “CTL” is selected by using the COUNTER button, and the control signals are backed up.
With the following button operation, it is possible to cue up to the starting and stopping points of the recording.
STOP + REW
Press the REW button while the STOP button is pressed
to cue up to the starting point of the recording.
STOP + FF
Press the REW button while the STOP button is pressed
to cue up to the starting point of the recording.
<Note>
If the time code is not successive, it is impossible to cue up
to the starting point of the recording properly. Execute the
following settings.
z Menu item No. 154 AUTO BACK:
“REC-P” or “ALL”
z Menu item No. 503 TCG MODE:
“REGEN” or “AUTO”
1 Execute the recording with pauses.
2 Press the REW button while the STOP button is pressed.
The tape cues up to the starting point of the recording
with an accuracy of ±1 frame.
3 Press the PLAY button to confirm the recording.
4 Press the FF button while the STOP button is pressed.
The tape cues up to the stopping point of the recording
and stops 5 to 10 frames before the stopping point.
5 Press the PAUSE button and then the REC button to
move to the REC PAUSE mode.
The tape cues up to the stopping point of the recording
and stops 5 to 10 frames before the stopping point.
<Notes>
z In the backup operation, only the time codes of the last
event recorded with pause are stored.
z Even if the recording is stopped by pressing the STOP
button, the stopping point of the recording is backed up.
z Cueing up from a portion where nothing is recorded
cannot be executed properly.
z If the FF/REW button is pressed during the cue up
operation, the unit moves to the ordinary search mode.
z When the power is turned off, backup data stored when
starting the recording and completing the recording will be
cleared.