Filter
Top Products
27
Jog mode
Jog/Shuttle
1
Press the JOG button.
Shuttle mode
1
Press the SHTL button.
3
To transfer the VTR from the jog mode to another
mode, press the button that corresponds to the
mode concerned.
2
Turn the search dial.
The dial’s click-stops are released, and the tape is
played back at the speed corresponding to the
speed at which the dial is turned.
The maximum jog speed can be changed by
selecting the setup menu item No.310 (JOG FWD
MAX) and No.311 (JOG REV MAX) settings.
When the dial is no longer turned, a still picture will
appear.
2
Turn the search dial.
The playback picture speed changes from 0 up to
w
32
k
depending on the dial position.
This speed can be switched to
w
9.8
k
,
w
16
k
or
w
32
k
using setup menu item No.101 (SHTL
MAX).
The dial has a click-stop at the center position
where a still picture will appear.
3
To transfer the VTR from the shuttle mode to
another mode, press the STOP button or the
button of the mode concerned.
Variable mode
1
Press the VAR button.
3
To transfer the VTR from the variable mode to
another mode, press the STOP button or the
button of the mode concerned.
2
Turn the search dial.
The playback picture speed changes from
j
4.9
k
to
i
4.9
k
depending on the dial position.
The maximum shuttle speed can be changed by
selecting the setup menu item No.308 (VAR FWD
MAX) and No.309 (VAR REV MAX) settings.
Noise will be generated at all speeds other than
j
1
k
to
i
2
k
. (For all tapes other than DVCPRO
HD-LP recorded ones, the noise-free speed range
is
j
1.0
k
to
i
1.1
k
.)
<Note>
At the factory setting, the VTR is set to be transferred
to the shuttle mode, jog mode or variable mode when
the search dial is turned.
In cases where it is not convenient for the VTR to be
transferred directly to the variable speed mode, it can
be transferred via the search button. Select “KEY” as
the setup menu item No.100 (SEARCH ENA) setting.