Filter
Top Products
53
Search mode
The desired search point can be selected, and the
tape can be prerolled to that point.
When the display page has been changed using the
[ (PREV) or (NEXT) button on the <CUE>
menu, the following applies depending on the setting
for (PAGE) on the <CUE SHIFT> menu.
When “MANU” is set:
Both the search and registered points move to the top
of the changed page.
When “AUTO” is set:
Only the search point moves to the top of the changed
page; the registered point does not move.
Cue point registration
Turn the ADJUST dial to highlight the point which is to
be registered. When the button is pressed, the
current tape position is registered as the cue point.
The following applies depending on the setting for
(PAGE) on the <CUE SHIFT> menu.
When “MANU” is set:
Operations are performed on the selected page.
Press the button to register the points in
succession (CUE
¢
1
>
CUE
¢
2
>
...
>
CUE
¢
6) on
the selected page. (Any points already registered will
be overwritten.)
The registration is automatically terminated when
CUE
¢
6 is registered on the page. (*
1
)
A change must be made to the points to be registered
if more cue points are to be registered. Check that
the cue point registration mode is established, change
the page, and change the points to be registered. In
this case, the search point will also move
automatically to the top (CUE
¢
1) of the changed
page.
(*1)If “ON” is selected as the ] (ROTATE) setting
on the <CUE SHIFT> menu, the registration of the
cue points will rotate on the same page in the
following order: CUE
¢
1
>
CUE
¢
2
>
...
>
CUE
¢
6
>
CUE
¢
1
>
CUE
¢
2
>
...
F4
SET
F3
SET
F3
F2F1
When “AUTO” is set:
When a page become full during the cue point
registration process, operation automatically moves to
the next page, and registration continues. When
CUE96 on the last page is reached, registration is
automatically terminated. (*
2
)
A change must be made to the points to be registered
if more cue points are to be registered. Check that
the cue point registration mode is established, change
the page, and change the points to be registered. In
this case, the search point will not be changed.
(*2)If “ON” is selected as the (ROTATE) setting
on the <CUE SHIFT> menu, the registration of the
cue points will rotate from page 9 (CUE96) to
page 0 (CUE01).
When registering cue points by number
1. Turn the ADJUST dial to highlight the desired
registered point display area.
2. Press the button twice. Only the “10’s” hour
digit of the selected cue point is now highlighted,
and the change enable status is established.
<Note>
When “REV” has been selected as the setup menu
item No.144 (TC INPUT) setting, the input of the
number will start from the higher-order digit (it will
be displayed starting from the far right).
3. Input the number using the number keys.
Movement from one digit to the next is done
automatically after one number has been input.
The desired digit can also be selected by turning
the ADJUST dial.
4. To enter the number, press the button.
When the display screen is switched or when the
button is pressed during the input process, the
change enable status is released, and the setting is
canceled.
C
ENT
T
F4
Function menus
<CUE>
CUE