Filter
Top Products
Timer recording allows you to automatically start and stop
a recording at a later date.The DVD recorder system
switches to the right programme number and starts
recording at the time entered.
You can pre-programme up to 6 recordings within a period
of one month.
Following information has to be keyed in to make a timer
recording:
– the date of the recording
– the programme number of the TV channel
– the start and stop time of the recording
– VPS/PDC on or off
– the recording mode
This information is saved in a timer block.
VPS and PDC
With Video Programming System and Programme
Delivery Control the TV station controls the start and the
duration of recordings.The DVD recorder system switches
itself on and off at the right time even if a TV programme
starts earlier or ends later than scheduled.
Usually the start time is the same as the VPS/PDC time.
However, if your TV magazine indicates a time that differs
from the programme’s start time (e.g. programme start
20.15 and VPS/PDC 20.14), you have to key in 20.14 as
start time.
If you want to key in a time that differs from the VPS/PDC
time, you have to switch off VPS/PDC.
Only one TV programme on a TV channel at a time can be
controlled using VPS/PDC. If you like to record two or
more TV programmes on a TV channel by using VPS/PDC,
you have to programme them separately.
NexTView Link
This DVD recorder system is equipped with NexTView Link.
In case your TV set is also equipped with this function, you
can mark TV programmes on the TV for programming.These
TV programmes will be transmitted automatically in the
timer block on the DVD recorder system for recording. If
you clear the marking on the TV, the corresponding timer
block on the DVD recorder system will also be cleared. For
further information, please see the instruction manual of your
TV set.
Note: If the TV station does not send the necessary signal,
NexTView Link will not work.
Timer recording
44
English