Filter
Top Products
90
Chapter 7
Using the AV Source (Pioneer AV Equipment) AV
TV Tuner
• For safety reasons, visual images cannot
be viewed while your vehicle is in motion.
To view visual images, you must stop in a
safe place and put on the parking brake
before setting your route (see page 12
Interlock for details).
Watching the TV tuner
You can use the Navigation System to control a
TV tuner, which is sold separately.
For details concerning operation, refer to the TV
tuner’s operation manual. This section provides
information on TV operations with navigation unit
that differ from those described in the TV tuner’s
operation manual.
When you attempt to watch visual images while
driving, the warning Viewing of front seat
video source while driving is strictly prohib-
ited. will appear on the screen.
(1) Source icon
Shows which source has been selected.
(2) Band indicator
Shows which band the TV tuner is tuned to.
(3) Preset number indicator
Shows which preset has been selected.
(4) Channel indicator
Shows which channel the TV tuner is tuned.
(5) Preset list display
Shows the preset list.
1 Touch the source icon and then touch
“TV” to select the TV.
2 Touch “BAND” to select a band.
Touch “BAND” repeatedly until the desired
band is displayed, TV1 or TV2.
3 To perform manual tuning, touch or
briefly.
The channels move up or down step by step.
You can also perform manual tuning by mov-
ing the joystick left or right.
4 To perform seek tuning, keep touching
or for about one second and
release.
The tuner will scan the channels until a broad-
cast strong enough for good reception is
found.
You can cancel seek tuning by touching either
or briefly.
If you keep touching or you can
skip broadcasting channels. Seek tuning
starts as soon as you release the keys.
You can also perform seek tuning by holding
the joystick left or right.
Storing and recalling broadcast
stations
If you touch any of the preset tuning keys P1—
P12 you can easily store up to 12 broadcast sta-
tions for later recall with the touch of a key.
1 When you find a station that you want to
store in memory keep touching a preset
tuning key P1 — P12 until the preset
number (e.g., P.ch: 1) stops flashing.
The number you have touched will flash in the
preset number indicator and then remain lit.
The selected station has been stored in mem-
ory.
The next time you touch the same preset tun-
ing key P1 — P12 the station is recalled from
memory.
To switch between P1 — P6 and P7 — P12,
touch or .
When the touch panel keys are not displayed,
you can display them by touching the screen.
❒ Up to 24 stations, 12 for each of two TV
bands can be stored in memory.
(2)(1) (4)
(5)
(3)
TV