Filter
Top Products
Appendix D: Informational Notes
248
Keyboard Configuration to use
Dell Dimension
2400– BIOS A05
Set the Host Interface to PS/2 on the
Keyboard/Mouse Setup page. See
Keyboard/Mouse Setup (on page 143).
Dell Optiplex 170L
- BIOS A07
PS/2 plus a PS/2-to-USB-adapter.
Set the Host Interface to PS/2 on the
Keyboard/Mouse Setup page. See
Keyboard/Mouse Setup (on page 143).
Dell Server 1850 In order for BIOS version A06 to recognize a
virtual media mounted removable USB flash drive,
use the PS/2 and USB connections between the
Dell server and the KX II-101.
Set the Host Interface to PS/2 on the
Keyboard/Mouse Setup page. See
Keyboard/Mouse Setup (on page 143).
HP UX RX 1600 Keyboard and Mouse Configuration
If you are using an HP UX RX 1600 running UNIX, do the following to
connect the device to the target:
• Verify you are using KX II-101 firmware 2.0.20.5.6964 or higher.
• Use the USB cable that is supplied with the KX II-101 .
• Set the Host Interface field on the Keyboard/Mouse Setup page to
USB. See Keyboard/Mouse Setup (on page 143).
• Verify that th
e Enable Ab
solute Mouse and Use Full Speed
checkboxes on the Port page are not selected. See Port
Configuration (on page 154).
• Use eithe
r
Intelligent or Standard Mouse mode. Do not use Absolute
Mouse mode.
Compaq Alpha and IBM P Server Mouse Mode Limitation
When connecting to either Compaq Alpha servers or IBM P servers
through the KX II-101, you must use Single Mouse mode. See Working
with Target Servers (on page 32).