Filter
Top Products
Chapter 2: Installation and Configuration
31
11. To configure new network settings, at the Network prompt, type
interface followed by one of the following commands and its
appropriate argument (option), then press Enter.
Command Argument Options
ipauto none|dhcp none - Enables you to manually specify
an IP address for the device. You must
follow this option with the ip command
and the IP address, as shown in the
following example:
interface ipauto none ip
192.168.50.12
dhcp - Automatically assign an IP address
to the device on startup.
ip IP address The IP address to assign to the device. To
manually set an IP address for the first
time, this command must be used with the
ipauto command and the none option.
See ipauto for information. After you have
manually assigned an IP address once,
you can use the ip command alone to
change the IP address.
mask subnetmask The subnet mask IP address.
gw IP address The gateway IP address
mode mode The Ethernet mode. You have the
following choices:
auto - Automatically sets speed and
interface mode based on the network.
10hdx - 10 MB/s, half duplex.
10fdx - 10 MB/s, full duplex
100hdx - 100 MB/s, half duplex
100fdx - 100 MB/s, full duplex
• When you have successfully changed a setting, you see a
confirmation message like the following:
1. When you are finished configuring the KX II-101, type logout at the
command prompt and press Enter.
You are logged out of the command line interface.