Filter
Top Products
Chapter 2: Installation and Configuration
23
Diagram key
PS/2 connection from the KX II-101 to the mouse (optional
cable)
PS/2 connection from the KX II-101 to the keyboard
(optional cable)
Video connection to the local monitor (optional cable)
Network
Connect a standard Ethernet cable from the network port labeled LAN to
an Ethernet switch, hub, or router. The LAN LEDs that appear above the
Ethernet connection indicate Ethernet activity. The yellow one blinks
while the KX II-101 is in use, indicating IP traffic at 10 Mbps. The green
light indicates a 100 Mbps connection speed.
Admin Port
The Admin port enables you to perform configuration and setup for the
KX II-101 using a terminal emulation program like HyperTerminal. Plug
the min-DIN end of the included serial cable into the Admin port of the
KX II-101 and plug the DB9 end into a serial port on your PC or laptop.
The serial port communication settings should be configured to the
following:
• 115,200 Baud
• 8 data bits
• 1 stop bit
• No parity
• No flow control
See Configure the KX II-101 Using a Terminal Emulation Program
(Optional) (on page 29) for additional information on using a terminal
emulatio
n pro
gram.