Runco DTV-1200 CRT Television User Manual


 
Remote Commands to the Projector
Pointing the Remote to the reflective screen
Point the front of the Remote to the screen surface.
Ceiling
Screen
IR sensor
Remote
Point the front of the Remote towards one of the IR sensors in the projector.
Front of projector
Rear side of project
or
Remote
ONOFF
POWER / MAINS
800 peripherals
RGB
Comp-/H-SyncV-Sync
COMM. PORT PORT 3
PORT 4/5
V-nom
I-nom
Freq
See installation instructions before connecting to the supply.
Voir la notice d'installation avant de raccorder au réseau.
120/230 V
7/5 Amp
50/60 Hz
S-VIDEO OFF - ON
75 Ohm
VIDEO
green : operation
red : standby
PORT 2
PORT 1
OFF - ON
75 Ohm
PROJECTOR MODE
"This devicecomplies with Part
15
of
the FCC Rules.
Operationissubject to
following twoconditions:(1) This
devicemay notcauseharmfulinter-
ference,and(2)this devicemust
acceptanyinterferencereceived,
includinginterferencethat may cause
undesired operation"
F1
F2
F3
F4
F5
ADJ
EXIT
ENTER
PAUSE
PHASE
TEXT
SHARPN
TINT
COLOR
BRIGHTN
CONTR
TREBLE BALANCE
BASS
VOL
9
0
7
8
5
6
34
1
2
F1
F2
F3
F4
F5
ADJ
EXIT
ENTER
PAUSE
PHASE
TEXT
SHARPN
TINT
COLOR
BRIGHTN
CONTR
TREBLE BALANCE
BASS
VOL
9
0
7
8
5
6
34
1
2
45°
45°
45°
45°
When using the wireless remote control, make sure you are within the effective operating distance (30m, 100ft
in a straight line). The remote control unit will not function properly if strong light strikes the sensor window or if
there are obstacles between the remote control unit and the projector's IR sensor.
R
emote used in a hardwired configuration.
RS232 IN
RS232 OUT
IR
REMOTE
RS232 INRS232 OUT
IR
REMOTE
17
Plug one end of the remote cable in the
connector on the bottom of the Remote and
the second side in the connector in the rear
panel of the projector labelled 'REMOTE'.