Filter
Top Products
PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
Select with or
then <ENTER>
<EXIT> to return
PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
Select with or
then <ENTER>
<EXIT> to return
60
Power Up Mode
What can be done?
When pressing the power switch, the projector can start up in 'operating mode' or in 'stand-by mode'.
Operating mode: the projector start up and displays image.
Stand-by mode: the projector start up in stand-by and waits until the stand-by button or a digit key is pressed.
Ho
w to change the mode?
To change the Power up mode:
1. Push the cursor key or to highlight Power Up (menu 1).
2. Press ENTER to toggle between 'Operating' and 'Standby'.
menu 1
W
hat can be done?
Every projector listens to a common address. This common address can be set to '0' or '1'. When a Remote is
programmed with a common address, every projector with that same common address will follow up the com-
mands given by that Remote.
W
hy 2 different common address?
The reason to have the choice to select between common addresses is, to avoid controlling of other IR con-
trolled units, e.g. a TV set with standard common address 0.
Ho
w to change the common address?
1. Push the cursor key or to highlight Common Address (menu 1).
2. Press ENTER to toggle between '0' and '1'.
Common Address
Note: Runco recommends that this be left in
‘Standby’ for long-term reliability.
menu 1