Filter
Top Products
COMMON SETTINGS
DYNAMIC ASTIGMATISM
GAMMA CORRECTIONS
CRT RUN IN CYCLE
CRT DRIVE MODE
MEMORYBANKS : ON
FLYBACK TURNOVER POINT
MENU POSITION : STANDARD
Select with or
then <ENTER>
<EXIT> to return
COMMON SETTINGS
DYNAMIC ASTIGMATISM
GAMMA CORRECTIONS
CRT RUN IN CYCLE
CRT DRIVE MODE
MEMORYBANKS : ON
FLYBACK TURNOVER POINT
MENU POSITION : STANDARD
Select with or
then <ENTER>
<EXIT> to return
72
Start Up
To start up the gamma corrections :
1. Push the cursor key or to highlight 'Gamma Corrections' (menu 1).
2. Press ENTER to start up. A warning screen will be displayed (menu 2).
Gamma Corrections
menu 1
WARNING
RISK OF INCORRECT ADJUSTMENT
OF THE PROJECTOR
THE GAMMA CORRECTIONS ARE
FACTORYADJUSTED USING COLOUR
ANALYSER! THEREFORE, ONLY
QUALIFIED INSTALLATION OR SERVICE
PERSONNEL SHOULD PERFORM
THESE ADJUSTMENTS !
<ENTER> TO CONTINUE
<EXIT> TO RETURN
menu 2
CRT Run In Cycle
What can be done?
Only necessary when a new picture tube is installed or when CRT arcing continues. The CRT run in cycle
option can only be activated when memory blocks on an internal # pattern are available. When one or more
such blocks are available, a flashing white image (5 sec on, 5 sec off) is generated and then for 5 min on the
first internal block. In the next 5 min, a second internal block will be used to generate the flashing white image.
The image will also be shifted in a vertical way to prevent a CRT burn in. To quit the CRT run in cycle option,
press EXIT.
Ho
w to select CRT run in cycle?
1. Push the cursor key or to highlight 'CRT run in Cycle' (menu 1).
2. Press ENTER to start up. If a memory block adjusted on an internal # pattern is available, the CRT run in
cycle will start. If no such a block is available, the projector cannot run the CRT run in option and leaves the
adjustment mode. If you still want to run CRT run in cycle, create first a memory block on an internal #
pattern and restart the CRT run in option.
menu 1
CRT RUN IN CYCLE
A flashing white pattern will be
generated until <EXIT> is pressed.
The projector only uses memory
blocks adjusted on an internal
# pattern; if no such block is
available, the projector can't run
the procedure and leaves the
adjusment mode.
<ENTER> to continue
<EXIT> to cancel
menu 2