Filter
Top Products
PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
Select with or
then <ENTER>
<EXIT> to return
56
What can be done?
The password code (4 digits) can be changed to a new one.
This item is password protected. First the actual password should be entered before continuing.
Note:
Password function is only active if the jumper on the controller is in the 'ON' position.
Ho
w to select?
To select Change Password :
1. Push the cursor key or to highlight 'Change Password' (menu 1).
2. Press ENTER to display the password menu (menu 2).
If it is the first time you enter a password protected item, enter your password and press ENTER.
The current password is displayed. The new password must consist of 4 digits between 0 and 9.
Ho
w to enter a new password?
Perform the following:
1. Push the cursor key or to select the digits to be changed (menu 2).
2. Press a numeric keys to enter the new digit.
3. Repeat for the other digits.
4. Press ENTER to save the new password.
Before saving the new password, a confirmation screen will be displayed (menu 3).
5. When the displayed password is correct, press ENTER to save.
6. If not correct, press EXIT to cancel the saving.
Change Password
menu 1
PASSWORD
Enter new password :
0 0 0 0
Use and to select,
and reprogram
with numeric keys.
<ENTER> to confirm
<EXIT> to return
menu 2
CHANGE PASSWORD
Password will be
reprogrammed as xxxx
<ENTER> to confirm
<EXIT> to cancel
!
menu 3