Runco DTV-1200 CRT Television User Manual


 
MESSAGES, WARNINGS AND FAILURES
INPUT 01
RGB2
Fh= 15.6 kHz
Fv= 050 Hz
SOURCE 01
RGB2
enter
password
x x x x
TEXT on
SOURCE 01
RGB2
xxxkHz
xxHz
TEXT off
PROJECTOR
ADDRESS :
003
WRONG
PASSWORD
!!!
When selecting a new source, informa-
tion about this source will be displayed
on the screen. Source number, hori-
zontal and vertical frequencies of the
displayed source.
Announcement of the selected source.
Message to enter your password.
Password contains 4 digits.
These messages will be displayed on
the screen when pushing the TEXT
key.
Text ON : the 'bar scale indication' will
be enabled during the change of an
analog control in the 'operational mode'
+ all warnings and failures will be dis-
played.
Text OFF : the 'bar scale indication' will
be disabled during the change of an
analog control in the 'operational mode'
+ all warnings and failures will not be
displayed.
Indication of the projector address
when activating the 'ADDRESS' button
on the Remote with a pencil or other
small object.
Message when the entered password is
wrong.
WARNING :
source not
available
WARNING :
invalid
key entry
WARNING :
end of ad-
just range
WARNING :
input
no longer
available
WARNING :
invalid
frequency
input
WARNING :
permanent
BOOST mode
in use !!!
WARNING :
Option not
installed !
WARNING :
Invalid Code Entry
The input is a valid input but the
source is not connected to the
input terminals or the input source
is switched off.
When a wrong key is pressed on
the Remote.
End of adjustment range.
The input source is no longer
available.
The entered frequency or applied
frequency of the source is out of
the projector's range.
The CRT drive mode is switched
to permanent boost.
Option not installed. e.g. Video
selected but no decoder installed.
The entered password is incorrect
79