Filter
Top Products
PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
Select with or
then <ENTER>
<EXIT> to return
55
How to start up?
To select Identification:
1. Push the cursor key or to highlight Identification (menu 1).
2. Press ENTER to select. The identification screen will be displayed (menu 2).
PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
Select with or
then <ENTER>
<EXIT> to return
menu 1
RUNCO
DTV-1200
Proj. address: 001
Soft. Version: 6.00
Config.: Ceiling/Front
Baud Rate PC: 9600
Text: ON
Serial No.: 103589552
Projector level: 1
menu 2
Run Time
What can be displayed?
The total sytem run time since the first start up can be displayed plus the run time of the separate CRT's since
the last reset.
R
un Time Note:
All projectors leave the factory after a burn-in period of approximately 100 hours.
Ho
w to start up?
To select the different Run Times:
1. Push the cursor key or to highlight 'Run Time (menu 1).
2. Press ENTER to display the run time menu (menu 2).
The amount of time the projector has run since its first start up at the factory will be displayed as the system
run time. The CRT run times will be displayed next to the respective colors.
menu 1
RUN TIME
SYSTEM RUNTIME : 120 h
CRT RUNTIME :
RED : 20 h
GREEN : 20 h
BLUE : 50 h
Select with or
then <ENTER>
<EXIT> to return
menu 2
How to reset the CRT run times?
1. Push the cursor key or to highlight the color of the CRT for which
the Run Time has to be reseted (menu 1).
2. Press ENTER to reset the run time.
3. Press EXIT to return to the Projector Set up menu.
RUN TIME
SYSTEM RUNTIME : 120 h
CRT RUNTIME :
RED : 20 h
GREEN : 20 h
BLUE : 50 h
Select with or
then <ENTER>
<EXIT> to return
menu 2