Filter
Top Products
18
Projector Address
Why a projector address?
Since more than one projector can be installed in a room, the separate projectors can be separately address-
able with a Remote or a computer.
Set up an Indi
vidual Projector Address
The set up of a projector address can be done via the software.
See 'Change Projector Address' in Chapter 'Service Mode'
Ho
w to control the projector or projectors?
The projector's address may be set to any value between 0 and 255 which can be set in the Service Mode.
When the address is set, the projector can be controlled now with:
- the Remote for addresses between 0 and 9.
- a Control System for addresses between 0 and 255.
Note: A projector will respond to a Remote set to the common address ('0' or '1') regardless of what address is
set in the projector itself.
Common
Address
Every projector has a common address '0' or '1'. The choice between '0' and '1' can be selected in the Service
mode.
Bef
ore using the Remote
The Remote is default programmed with address 0 or 1, 'common address'. With that 'common address' pro-
grammed into the Remote, every projector, with the same common address set up, will listen to the commands
given by this Remote. If it is necessary to control a specific projector, than enter the projector address into the
Remote (only when that address is between 0 and 9). The projector with the corresponding address will listen to
that specific Remote.
Displa
y the Projector Address on the Screen.
Press the ADDRESS key (recessed key on the Remote) with a pencil. The projector's address will be displayed
in a 'Text box' (menu 1). This text box disappears after a few seconds.
PROJECTOR ADDRESS
001
To continue using the Remote with that specific address, it is necessary to enter the same address with the digit
buttons (address between 0 and 9) within 5 seconds after pushing the address key. For example: if the Address
key displays projector address 003, then press "3" digit button on the Remote to set the Remote's address to
match the projector's address. Do not press 003 digits. This will address the remote control to '0' and control all
projectors in the room.
If the address is not entered within 5 seconds, the Remote returns to its default address (zero address) and
control all projectors in the room.
Ho
w to program an address into the Remote?
Press the ADDRESS key (recessed key on the Remote) with a pencil and enter the address with the digit but-
tons within 5 seconds after pushing the address key. That address can be any digit between 0 and 9.