Sanyo VA-SW8000LITE DVR User Manual


 
English 108
DVR Management Menu (Required user access level: ID4)
To resume a stopped recording session:
When [OVERWRITE] is set to “OFF” and the
hard disk runs out of free space during a
recording session, the system automatically
stops the recording session.
If this is the case, you can click the [Disk Full
Reset] button to switch to the overwrite mode
and resume the recording session.
4 SERIES REC (default: OFF)
When multiple DVRs are connected in series
via their SERIES REC terminals, you can
enable the Series Recording mode, in which a
recording session is automatically continued
from one hard disk to another when the first
hard disk becomes full and unable to
accommodate the video data, and so on.
When you use the Series Recording mode,
you have to specify how many minutes earlier
than the hard disk becoming full the series
recording mode should be activated.
Available options:
OFF: Disables the Series Recording
mode.
-1M: One minute earlier
-2M: Two minutes earlier
-3M: Three minutes earlier
5 ALARM MODE (default: ENABLED)
By selecting an option from the drop-down
list, you can control how the alarm mode
should work in combination with the timer
recording feature.
Available options:
OFF: Disables the alarm recording
mechanism.
ENABLED:
Always enables the alarm recording
mechanism, independently of the timer
recording settings.
AL-REC ON TIMER:
Enables the alarm recording mechanism
only when a timer recording is in
progress.
AL-REC OFF TIMER:
Enables the alarm recording mechanism
only when the timer recording is not in
progress.
OLY AL-REC ON TMR:
Enables the alarm recording mechanism
only during the hours for which a timer
recording is scheduled.
(In this case, setting up the timer recording
feature does not put it into standby state.)
The system switches to the overwrite
mode when you resume the stopped
recording session using the [Disk Full
Reset] button. In this case, however,
the system behaves differently than
when the “ON” radio button is
selected in the [OVERWRITE] section
on the window: it exits from the
overwrite mode as soon as the
recording session restarts. Thus, if
the disk runs out of space again, the
system stops the recording session
again.
To remain in the overwrite mode, you
have to select the “ON” radio button
in the [OVERWRITE] section on the
window.
The [Disk Full Reset] button is only
enabled when [OVERWRITE] is set to
“OFF” and the hard disk runs out of
free space.
This means that you cannot use the
[Disk Full Reset] button if there is any
free space on the disk.
The model DSR-M800 does not
support the Series Recording mode.