Filter
Top Products
25
strongly favor a resolution of at least 25
frames per second.
• Favor sharpness: the IP VCR will use the
highest resolution that is appropriate for
what is being viewed.
• Balanced: the IP VCR will select settings
that balance resolution and frame rate
(where the frame rate will not be less than
12 frames per second).
Transmitted
video
resolutions
Choose the setting for transmitted video resolutions
from the IP VCR to this endpoint. This setting
overrides the unit-wide setting on the
Settings >
Connections
page.
Retain the default setting (use box-wide setting)
unless you are experiencing problems with the
display of certain resolutions by this endpoint.
Endpoints advertise the resolutions that they are
able to display. The IP VCR then chooses from
those advertised resolutions, the resolution that it
will use to transmit video. However, some
endpoints do not display widescreen resolutions
optimally. Therefore, you might want to use this
setting to restrict the resolutions available to the IP
VCR for transmissions to this endpoint.
Preferred
bandwidth
from IP VCR
Preferred
bandwidth to
IP VCR
Use these fields to specify the preferred call
bandwidth from the IP VCR to the endpoint and
from the endpoint to the IP VCR, respectively.
If you choose use default value, the preferred
bandwidth is chosen to be the same as that set in
the global connection settings.
Custom codec
selection
Can be used to ensure only specific codecs are
permitted on calls to (and received from) this
endpoint.
If Enabled, you can choose which codecs are
allowed to be used when communicating with this
endpoint.
Configured endpoints
<Pre-
configured
endpoints>
Select one of the endpoints that has been configured
on the IP VCR to call by selecting it in the list and
clicking
Call selected endpoint.